Home » Infrastructure » Unix » how destroy the fork that cuase "fork failed - too many processes" ?
how destroy the fork that cuase "fork failed - too many processes" ? [message #367116] Wed, 13 December 2000 00:31 Go to next message
Angus
Messages: 18
Registered: October 2000
Junior Member
Hi,
I am try attempt to write the Remote Procedure Call(RPC) program. The system show me the error message "fork failed - too many processes". It may be caused by several compiling and running the program. How can I prevent the above problem. Any one could help me to solve it or give me some advice.
Thanks a lot.
Regards,
Angus

Report message to a moderator

Re: how destroy the fork that cuase "fork failed - too many processes" ? [message #367121 is a reply to message #367116] Tue, 19 December 2000 06:11 Go to previous message
Thomas
Messages: 67
Registered: September 1999
Member
Hi,
i assume you are using UNIX. The error message indicates that you might check your kernel parameters regarding the maximum number of processes in your system. Probably this should be increased. If your init.ora parameter "processes"is set too small it might also cause this problem.

thomas

Report message to a moderator

Previous Topic: Multiple Instances on one box
Next Topic: When create database under svrmgrl occur ora3113 Error
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Sat Nov 30 01:16:27 CST 2024
.:: Forum Home :: Blogger Home :: Wiki Home :: Contact :: Privacy ::.